Home

CPVAN Wireless Interlinked Smoke, Heat & Carbon Monoxide Alarm Bundle with Remote Control

  • 【Pre-Linked】 3 x Smoke Alarm, 1 x Heat Alarm, 1 x Carbon Monoxide Detector, 1 Remote Control. This bundle has been ‘Pre-Linked’ without any set-up, so there is no need to worry about testing over and over and upsetting the neighbors. Simply turn on the alarm, test them and then install them on the required ceiling.
  • 【Compliant with New Scottish & English Regs】Totally compliant with Both The New Scotland Regs (Feb 2022) and The New England Regs (Oct 2022). Certified to BS EN14604:2005/AC:2008, BS 5446-2:2003 & EN 50291-1:2018 standards.
  • 【Equipped with a Remote Control】 The interlinked smoke and heat alarm is equipped with a remote control which you can use to pair, test and silence the fire alarm at any time without having to test it with a pole or carry a ladder up and down. This is very kind and safe for the elderly.
  • 【Advanced Sensor】 With photoelectric sensor, this linked smoke alarm reacts faster to dangerous smoke than conventional alarms. Our heat alarms utilise an ultra sensitive thermistor sensor that reacts instantly when the ambient temperature exceeds the safe limit. This carbon monoxide detector is built electrochemical CO sensor to deliver high consistency and reliability for double detection and protection.
  • 【Wireless Interlinked Alarms】 Up to 30 wireless alarms can be linked together so that these networked fire alarms sets can monitor the whole house. If one of the interlinked alarms triggers an alarm, all others also sound the alarm! Whether it’s a children’s room, hallway or basement, thanks to a range of 100 m, the warning penetrates every corner of your home.
  • 【10 Year Sealed Battery】 The carbon monoxide alarm is built in a CR17505 lithium battery with a capacity of 2800mAh. The smoke and heat alarm has two built-in CR14505 lithium batteries with a capacity of 3200mAh. Low consumption, achieving an amazing 10-year life with maximum reliability. Saves you from frequent battery changes and provides uninterrupted 24/7 protection, even during power outages.
  • 【Easy to Install】Very easy to install, complete with screws and anchors and adhesive pads. No wiring is required for installation. Using screws and anchors or strong adhesive pads, it only takes a few minutes to mount the fire alarms scotland interlinked on any wall or ceiling. If you want to use the carbon monoxide alarm directly without mounting it, you can place it directly on the table. So easy!

Was £129.99 Now £110.49


eTeknix uses affiliate links, which means we may earn commission from our links.

James Cusworth

Disqus Comments Loading...
Share
Published by
James Cusworth

Recent Posts

Tapo 2K Solar Security Camera Kit 

[Uninterrupted Power Supply with 45 min Super Fast Charging】Tapo TC82 KIT is the battery camera…

27 mins ago

fanxiang 1TB SSD 

Fast Response: Fanxiang 1TB SSD uses SATA III 6Gb/s interface and 3D QLC NAND Flash,achieving…

29 mins ago

ARZOPA 16.1” 144Hz Portable Monitor

[16.1" 144HZ] ARZOPA Z1FC portable monitor has 144Hz ultra-high refresh rate for higher motion clarity…

30 mins ago

Fikwot M.2 SSD 2TB, NVMe SSD

【Lightning-fast Top Performance】: Fikwot FX991 M.2 SSD 2TB adopts NVMe protocol and PCIe Gen 4x4…

31 mins ago

Acer Predator GM7 2TB SSD

PCIe 4.0 Gen4: The high-performance Predator GM7 delivers uncompromising speeds up to 7400 MB/s read-…

34 mins ago

G.Skill Memory Helps Achieve DDR5-12000 Memory OC on Core Ultra 9 285K

In a groundbreaking achievement, four overclockers have surpassed the DDR5-12000 milestone using G.Skill DDR5 memory…

2 hours ago