EVGA has been teasing fans with their upcoming Z390 DARK overclocking motherboard on social media. What sets it apart from other boards is the fact that it does not stick to the typical board layout. Its CPU socket as well as DDR4 DIMM slots are rotated counter-clockwise.
Although EVGA did not exactly officially announce this motherboard yet, we can safely say that this is the next Z390 DARK motherboard. How? Well for starters, they are not going to put a locked chipset like a B360 on a motherboard that is for overclocking.
Secondly, we know that this is not an HEDT platform due to the size of the socket. Plus, we know that new Z390 motherboards are coming out soon. It does not really bring much over the Z370 chipset other than built-in WiFi support, so manufacturers are coming up with unique ways to sell the platform to consumers. So it only makes sense that this board will be a using a Z390 chipset.
Lastly, we can see the word “DARK” in one of the photos on the top edge of the board, so it could only be a Z390 DARK motherboard.
Having the CPU and DIMM slot rotated counter-clockwise makes more sense from an airflow stand point inside a chassis. The cool air intake comes from the front side which is the right side of the board. That means airflow to the CPU socket gets blocked by the DIMM slot. With the new layout, both the RAM and the CPU are at the path of the airflow simultaneously.
The new connector layout is also much friendlier for cable management. There is no need to route the 8-pin cable around when it is in the same area as the 24-pin connector and the USB 3.0 front panel.
The connector cables for both the 24-pin and 8-pin ATX power are also right beside each other. Typical motherboard layouts have the 24-pin on the right side with the 8-pin at the top left. Furthermore, EVGA has positioned these at a 90-degree angle and are recessed. Beside them is a 19-pin USB 3.0 header which is also at a 90-degree angle.
Even though the teaser photos only show a partial view of the board, we can already see a lot of features. There are on-board power, reset and CMOS clear buttons on the top right corner. A built in USB 2.0 port (not header) is also ready in that area. Plus two port-80 debug LEDs near the top edge.
On first glance, it might seem like the motherboard has a micro-ATX layout. However, that does not seem to be the case since there is a toggle switch for the PCIe slots visible behind the front panel USB 3.0 header. It shows that there is a DIP switch with five options, most likely for disabling the expansion slots. There is also a USB 3.1 front panel header visible below the USB 3.0 header.
The BIOS is also a socketable-type, with a 3-setting toggle switch to select which to use. It even has LED indicators which light up to show which BIOS chip is being loaded. Although from the photos, we can only see one BIOS chip visible.
We just have to wait and see since the launch is almost here. Either way, it is nice to see a big effort being made in having a unique Z390 offering in the market. Instead of just adding RGB LEDs and calling it a day.
According to a new report, the GeForce RTX 5090 GPU will be very expensive. It…
A new AMD processor in the form of an engineering model has been leaked in…
SK Hynix has claimed to be the first company to mass-produce 321-layer NAND memory chips.…
SOUNDS GREAT – Full stereo sound (12W peak power) gives your setup a booming audio…
Special Edition Yoshi design Ergonomic controller shape with Nintendo Switch button layout Detachable 10ft (3m)…
Fluid Motion: These flight rudder pedals are smooth and accurate that enable precise control over…