Raijintek Atlantis Series Custom Loop Water Cooling Review

A Closer Look – RAI-PM5 Pump

Next up we have the pump, which comes boxed in protective foam, with four mounting screws/bolts, and a simple setup guide.

The design is tailored to allow you to fit your own barbs right into the top but comes pre-installed with a male-to-male barb, allowing you to mount a reservoir directly to the top of the pump. There’a standard fan header for power, but it’s Y-split with a removable power control dial, allowing you to increase/decrease the flow rate to suit the noise/performance ratio you require.

The pump comes mounted vertically on the mounting block, but can be unscrewed and mounted sideways, which means you can fit it to the sides, rear, or base of your system as required.

It’s a fairly compact unit, and feels pretty durable too, so should be a welcome addition to your loop. The flow pattern on this pump it in at the top and out at the port on the side.