Sharkoon RGB HEX ATX PC Case Review
Peter Donnell / 1 year ago
Hardware Support
There’s room in this case for an ATX motherboard, but the length is quite short to maintain a mid-tower form factor and a smaller footprint. That means that GPU length caps out at 350mm, so some of the truly titanic-sized RTX 4090s won’t fit in here. However, you can fit a 158mm tall CPU cooler, so most large air coolers should fit just fine.
In the top of the case, it can support up to a 240mm slim radiator.
The front will support up to a 360mm slim radiator, a 240mm thicker radiator, or a similarly sized push/pull configuration.
And in the rear, there’s a 120mm fan, but again, that could be swapped out for a similarly sized AIO radiator.
Having six pre-installed ARGB fans means lots of cables; six for the PWM and six for addressable 5V DRGB. Fortunately, the RGB ones are already wired up, and there are even two spare ports on the included hub! All the fans come with 3-pin headers and each has an optional and removable Molex adaptor should you need them.
Behind the motherboard, there’s room for two SSD brackets, and there are some HDD/SSD mounts on the left there too, albeit rudimentary screw holes, but they’ll get the job done. Plus, there are the SSD mounts on the shroud, and two HDD trays under the shroud too, so there’s plenty of room for storage.
The case will support up to a 215mm long PSU, so pretty much any standard ATX unit should fit just fine.
