Most docking stations are close to the same, but there are exceptions such as SilverStone‘s TS12C that I’m taking a closer look at today. It isn’t just a docking station for two drives, it also comes with a system-less cloning feature.
I loved SilverStone’s TS11C when I reviewed it last year, so I reached out to SilverStone as soon as I saw the TS12C being announced. At the base, it’s more or less the same unit, but with a cloning-mutation added. The basic design has stayed the same with the aluminium body, sturdy stand, and ABS plastic cover.
The added cloning feature requires a few more physical buttons and indicators. We get those in the form of access and progress LEDs as well as mode selection and start buttons. The direct usage of the cloning feature allows for a PC-less usage and that’s great. Especially when you clone something like an 8TB or 10TB HDD, then you’ll love the PC-less feature. It will take a long time and there is no need to occupy a system with the task when you don’t have to.
The SilverStone TS12C comes with the latest generation of USB connection. It gives it the performance to handle SSDs with full speed, allowing for great transfer speeds. The docking station uses USB 3.1 Gen.2 with up to 10Gbps bandwidth and that is plenty for a 6Gbps drive. The docking station also supports UASP (USB Attached Serial Protocol) for improved performance. The UASP feature allows for commands to be executed at once without the connected drive having to reply with a done command before receiving the next order.
The setup couldn’t be easier. Connect the power, connect the USB cable, and plug in a drive or two. Power it on and you’re good to go. A docking station principally allows for a tool-less installation where drives just are inserted. The TS12C supports both plug-and-play usage as well as drive hot-swapping.
There is full support for 2.5-inch and 3.5-inch drives in this docking station. The largest part of each drive bay is covered with a lid which folds back by itself when you insert a 3.5-inch drive. The 2.5-inch opening is always free.
While the SilverStone TS12C has two drive bays, it doesn’t support RAID 0 and RAID 1 setups. You can only run the disks in JBOD mode (Just a Bunch Of Disks) when connected to a PC. When the system isn’t connected to the PC, it works as a headless cloning station. At the press of a button, the TS12C will clone disk one onto disk two.
It doesn’t matter whether you use 32GB drives or 12TB drives, the SilverStone TS12C will take them all. There is no size limitation, at least not for the foreseeable future. All SATA drives are supported, from SATA 1 to 3, and so are small 2.5-inch and larger 3.5-inch drives.
The operations are handled by two controllers on the inside. Both are from ASMedia and they are the ASM1542 and the ASM1352R chips. The ASM1542 is a passive switch controller with 10Gbps support while the ASM1352R is ASMedia’s single chip solution to bridge the USB 3.1 to dual SATA interface.
According to a new report, the GeForce RTX 5090 GPU will be very expensive. It…
A new AMD processor in the form of an engineering model has been leaked in…
SK Hynix has claimed to be the first company to mass-produce 321-layer NAND memory chips.…
SOUNDS GREAT – Full stereo sound (12W peak power) gives your setup a booming audio…
Special Edition Yoshi design Ergonomic controller shape with Nintendo Switch button layout Detachable 10ft (3m)…
Fluid Motion: These flight rudder pedals are smooth and accurate that enable precise control over…