Thermalright Macho Rev.A (BW) CPU Cooler Review

Ryan Martin / 12 years ago

We always use the same test system with CPU coolers that we compare against each other. The full specifications of our test system are as follows:

Test system:

We’d like to say a big thank you to ASUS, Antec, Kingston, Cooler Master and Intel for providing components that makes this testing possible.

Testing Methodology:

We always use Gelid GC Extreme thermal paste to make sure testing reveals the efficiency of the tested coolers, not the efficiency of the bundled thermal paste.
Prime 95 is run for 10 minutes and then the average maximum temperatures as recorded by CPUID HWMonitor are noted
The system is left in idle for 10 minutes on the desktop and then the average minimum temperatures as recorded by CPUID HWMonitor are noted
Fans are always left to operate at PWM speeds, if this is not supported then 100% fan speed is used (and a low noise adapter for 3 pins if provided)
Delta temperatures are always used (Observed temperature minus ambient temperature) and we keep the ambient at 22 (+/- 1) degrees for all testing although Delta temperatures correct for the changing ambient anyway
The average temperature across the four cores is taken on our quad core Intel processor
Acoustic measurements are taken 10cm away from the CPU cooler with the VGA fan disabled
The cooling performance tests are run at stock 3.4GHz (with Intel Turbo up to 3.8GHz and stock voltage) and overclocked 4.5GHz (1.3 volts) settings
All other coolers in the graphs have been tested under identical settings
Each test is repeated 3 times for consistency of results
There is approximately a 1 degree celsius margin of error in our temperature recording software
There is approximately a 1dBA margin of error with our decibel meter

Software Used

Support eTeknix.com