Watercool has today announced the launch of its brand new Heatkiller V water block cooling solution designed specifically for Nvidia’s new high-performance GeForce RTX 3080 and 3090 graphics cards. – If you are, therefore, in the market for some strong temperature control on your new and shiny GPU, these new water block designs, available in various color options, are well worth checking out!
The inflow to the cooling structure has been completely reworked. It now is placed with a vertical offset on a second level. The inlet and outlet channels cross each other, but are spatially separated from each other. The new design allows a symmetrical arrangement of the cooling channels. The advantage of the symmetrical design is a steady flow through the heat sink. Dead zones and hotspots are thus effectively avoided. At the same time the windage is reduced.
With the new HEATKILLER V the extremely efficient cooling structure of the predecessor was further refined. The enlarged cooling surface ensures exceptionally low GPU temperatures. To reduce turbulences, all cooling channels were manufactured in a rounded design.
With the new design of the HK V there are no more screws in the visible area, which gives the cooler a very clean and unique look. The two acrylic nickel versions also feature integrated aRGB illumination. Here you will find an LED strip with an immensely high density of 144LEDs per linear meter. This unusually high number was intended to provide adequate illumination.
Insulating spacers and stainless steel reinforced threads
With Watercool’s experience gained in the industrial sector, this has brought the high-performance synthetic material “Peek” to attention. This material provides one hundred percent insulation between the cooler block and the graphics card’s circuit board. To avoid issues with the threads in the Plexiglas, we inserted a square nut made of stainless steel.
With the Pre-cut thermal the installation has never been easier before. The award-winning Thermal Grizzly Kryonaut thermal paste ensures the heat transfer from the GPU to the cooler. Even the maintenance has been thought of. By loosening two screws, the stainless steel respectively aluminum bezel can be removed.
At the time of writing, Watercool has not confirmed any specific regional release dates for its Heatkiller V water block design, nor how much we can expect it to cost when it does hit retailers. – If you do, however, want to learn more about this and other Watercool products, you can visit their official website via the link here!
What do you think? – Let us know in the comments!
According to a new report, the GeForce RTX 5090 GPU will be very expensive. It…
A new AMD processor in the form of an engineering model has been leaked in…
SK Hynix has claimed to be the first company to mass-produce 321-layer NAND memory chips.…
SOUNDS GREAT – Full stereo sound (12W peak power) gives your setup a booming audio…
Special Edition Yoshi design Ergonomic controller shape with Nintendo Switch button layout Detachable 10ft (3m)…
Fluid Motion: These flight rudder pedals are smooth and accurate that enable precise control over…